Speciality Valves
1 Warranty covers manufacturing defects in valve body, bonnet, stem, and seats.
2 Coverage against leakage under rated cryogenic temperatures and pressures.
3 Functional defects in extended bonnet or special low-temperature seals.
4 Repair/replacement of defective parts due to faulty material or assembly..
1 Damage due to improper handling, rapid temperature cycling, or incorrect insulation.
2 Seal/seat wear caused by repeated thermal contraction/expansion (normal use).
3 Corrosion or material degradation due to incompatible cryogenic fluids.
4 Failure caused by ice formation or lack of specified purging/maintenance.
1 Warranty covers defects in spring, lever, or safety mechanism.
2 Functional failure to open/close at calibrated safety set points due to manufacturing defects.
3 Coverage against leakage caused by faulty sealing surfaces.
4 Repair or replacement of valve if failure occurs under recommended operating limits.
1Tampering with factory set calibration or unauthorized adjustments.
2 Damage from exposure to aggressive chemicals or high-velocity particulate media.
3 Wear of seats, seals, or discs due to repeated actuation cycles.
4 Improper storage, handling, or installation (e.g., overtightening, incorrect alignment)..
1 Warranty covers manufacturing defects in body, rotor, and internal sealing components.
2 Functional failure to divert/redirect flow as per design due to defective mechanism.
3 Coverage for leakage at rated pressure and temperature conditions.
4 Repair/replacement of faulty unit under normal service operation.
1 Damage caused by excessive torque, incorrect actuator fitment, or forced operation.
2 Wear and tear of sealing surfaces or gaskets from regular switching.
3 Corrosion, scaling, or erosion caused by incompatible process fluids.
4 Improper mounting or misalignment during installation.
1 Warranty covers defects in strainer body, mesh element, and sealing surfaces.
2Assurance against leakage due to defective welds or casting faults.
3 Coverage for structural failure of mesh element due to poor manufacturing quality.
4 Repair/replacement of unit under specified flow/pressure conditions.
1 Clogging or damage caused by excessive dirt, debris, or lack of cleaning.
2 Normal wear and tear of strainer mesh element.
3 Corrosion/erosion caused by aggressive or incompatible media.
4 Operation beyond rated pressure, temperature, or flow capacity..